INSTRUCTIONS

Step 1: Disassemble the die. Degrease all part of the XMS die. The XMA dies does not require cleaning.

Step 2: Add a touch of vibra-tite 111 between the shoulder of the shaft and tip. Snug the shaft with a 3/16 wrench. Do not over tighten, or it may result in a snapped threaded shaft in the main shaft.

Step 3: Drop the optional case guide into the die. Drop the shaft through the threaded insert and slide the spring over the shaft. Turn into the die and hand tighten.

Step 4: Hand tighten the case and spring onto the die body.

Step 5: Place the case onto the plate of the reloading press. Turn the die into the press station until the die contacts the case floor. Tighten down 1/4 turn.

Step 6: Lock the die into place.