MAGNUM PRIMER POCKET SWAGE DIE INSTRUCTIONS
Video Instructions: How to set up and use your new Magnum Primer Pocket Swage Tools
Step 1: Refer to the Magnum Hold Down Die instructions to set up your die, and screw in the hold down tip on the end of the shaft.
Step 2: Place the primer pocket swage on the ram in place of the shell holder. Ensure you are using the correct swage size (small or large) depending on the size of the primer pocket you are swaging.
Step 3: Place the universal stabilizing extractor cup over the ram. The cup will fit on most all single stage and turret reloading presses.
Step 4: Set a case over the swage and raise the ram up all the way.
Step 5: Turn the die down until the hold down tip makes contact with the floor of the case. Tighten the die down 1/4 turn from there.
Step 6: Push the press lever down to drive the swage into the primer pocket. Check the swage. If more is required on the case, then turn the die down in small increments until the desired swage is achieved. Lock the die into place.