INSTRUCTIONS

Step 1: Hand turn the case hold down tip into the shaft. Put a touch of purple vibra-tite 111 on the threads of the tip where it meets the shaft. Snug the tip into the shaft with a 3/16th wrench. Do not over tighten.

Step 2: Drop the shafted tip into the die body. Drop the spring into the cap well.

Step 3: Thread the cap into the cap well. Tighten the cap all the way down snug against the o-ring. Back out the cap 1/4 turn.

Step 4: Place a case under the die. Depending on your reloading press, lower the tool head all the way down, or raise the ram all the way up. Turn the die into the tool head until the die mouth contacts the floor of the case.

Step 5: Tighten the locknut to lock it into place.