INSTRUCTIONS

Step 1: Screw pin into the shaft. Use 7/32" and 3/16" wrench on the flats on the shaft and the pin. Snug the pin into the shaft ⅛ of a turn. You can use purple or blue Locktight below the threads.  

Step 2: Drop the shafted pin into the die body.

Step 3: Drop the spring into the cap well. 

Step 4: Tighten the cap into the cap well with the spring. Strongly hand-tighten the cap.  

 Step 5: Lower the tool head or raise the ram.  

Step 6: Turn the die into the tool head until the mouth of the die contacts the plate or shell holder. Back out ¼ turn.  

Step 7: Turn locknut to lock it down.